株式会社極東書店トップ ＞ 商品一覧 ＞ Development of Infrared Techniques for Practical Defect Identification in Bonded Joints. 1st ed. 2016
商品詳細
Development of Infrared Techniques for Practical Defect Identification in Bonded Joints. 1st ed. 2016
・ISBN 978-3-319-22981-2 hard EUR 99.99
￥26,726.- (税込) ※（※）価格はご注文時の参考価格となります。
納品価格につきましては書籍の入荷時点で確定となります。
版元の原価改定、外国為替の変動等により異なる場合がございますので、予めご了承下さい。
| 著者・編者 | Waugh, Rachael C., |
|---|---|
| シリーズ | (Springer Theses) |
| 出版社 | (Springer International Publishing AG, SZ) |
| 出版年月 | 2015 |
| ページ数 | 149 pp. |
| 言語 | ENG |
| ニュース番号 | ＜A05-39235＞ |
解説
Maximizing reader insights into the use of thermography, specifically pulsed and pulse phase thermography (PT and PPT), for the identification of kissing defects in adhesive bonds, this thesis focuses on the application of PT and PPT for the identification of a range of defect types in a variety of materials to establish the effect of material properties on identification of defects.
Featuring analysis of a numerical model developed to simulate the thermal evolution created during a PT or PPT experiment, after validation through a series of case studies, this model is then used as a predictive tool to relate defect detectability to the thermal property contrast between defect and bulk materials.
Demonstrating a means of producing realistic kissing defects in bonded joints where insufficient thermal property contrast exists defects have a limited effect on heat propagation through a component and therefore are not detected using PT or PPT, this thesis discusses the addition of a small load to bonds containing kissing defects which was found to open the defects sufficiently to enable their detection.
A low cost infrared detector, Flir Tau320, is compared to the research based photon detector, Flir SC5000, and is shown to be suitable for application in PT, thus enabling a significantly lower cost tool to be developed.